Rockchip SoC MIPI RX D-PHY
-------------------------------------------------------------

Required properties:
- compatible: value should be one of the following
	"rockchip,rk1808-mipi-dphy-rx"
	"rockchip,rk3288-mipi-dphy"
	"rockchip,rk3326-mipi-dphy"
	"rockchip,rk3368-mipi-dphy"
	"rockchip,rk3399-mipi-dphy"
- clocks : list of clock specifiers, corresponding to entries in
	clock-names property;
- clock-names: required clock name.

MIPI RX0 D-PHY use registers in "general register files", it
should be a child of the GRF.
MIPI TX1RX1 D-PHY have its own registers, it must have a reg property.

Optional properties:
- reg: offset and length of the register set for the device.
- rockchip,grf: MIPI TX1RX1 D-PHY not only has its own register but also
		the GRF, so it is only necessary for MIPI TX1RX1 D-PHY.

port node
-------------------

The device node should contain two 'port' child nodes, according to the bindings
defined in Documentation/devicetree/bindings/media/video-interfaces.txt.

The first port show the sensors connected in this mipi-dphy.
- endpoint:
	- remote-endpoint: Linked to a sensor with a MIPI CSI-2 video bus.
	- data-lanes : (required) an array specifying active physical MIPI-CSI2
			data input lanes and their mapping to logical lanes; the
			D-PHY can't reroute lanes, so the array's content should
			be consecutive and only its length is meaningful.

The port node must contain at least one endpoint. It could have multiple endpoints
linked to different sensors, but please note that they are not supposed to be
actived at the same time.

The second port should be connected to isp node.
- endpoint:
	- remote-endpoint:  Linked to Rockchip ISP1, which is defined
		in rockchip-isp1.txt.

Device node example
-------------------

grf: syscon@ff770000 {
	compatible = "rockchip,rk3288-grf", "syscon", "simple-mfd";

...

	mipi_dphy_rx0: mipi-dphy-rx0 {
		compatible = "rockchip,rk3399-mipi-dphy";
		clocks = <&cru SCLK_MIPIDPHY_REF>,
			<&cru SCLK_DPHY_RX0_CFG>,
			<&cru PCLK_VIO_GRF>;
		clock-names = "dphy-ref", "dphy-cfg", "grf";
		power-domains = <&power RK3399_PD_VIO>;

		ports {
			#address-cells = <1>;
			#size-cells = <0>;

			port@0 {
				reg = <0>;
				#address-cells = <1>;
				#size-cells = <0>;

				mipi_in_wcam: endpoint@0 {
					reg = <0>;
					remote-endpoint = <&wcam_out>;
					data-lanes = <1 2>;
				};
				mipi_in_ucam: endpoint@1 {
					reg = <1>;
					remote-endpoint = <&ucam_out>;
					data-lanes = <1>;
				};
			};

			port@1 {
				reg = <1>;

				dphy_rx0_out: endpoint {
					remote-endpoint = <&isp0_mipi_in>;
				};
			};
		};
	};
};
