DVJ-1000: software & firmware updates

This update will improve the Master Tempo performance and readability of dirty or scratched discs.
You'll only need to update your DVJ-1000 if it has a System Version lower than 1.50.

Just follow the five easy steps below:

1. Check which version of the DVJ-1000 you own

• Turn the player on.
• Keep pressing RELOOP/EXIT button for over 10 seconds. Main version is displayed on FL display. After that, drive firmware version can be seen by pressing cursor(->) button.
• Remember, you'll only need to update if your System has a Version lower than 1.50.
• To return the DVJ-1000 player to its normal operating state, turn the player off and then on again.

2. Download the firmware

• The file is 4.68MB and was released on 17 January 2007
• If your browser does not automatically start the download process, be sure that your browser or security software is set to allow downloading of files from this web site.
• You can also right-click the button and select “Save Target As” to start the download process.

3. Check the Firmware File

Check the size (4.68MB) of the downloaded firmware file DVJ1000_V1.50.iso by right-clicking on the file and selecting Properties. (Download again if the file size is incorrect.)

4. Create the Update Disc

• It is important to use a good quality branded blank CD-R disc or completely erased CD-RW disc.
• Create the update disc by burning the file to a CD-R or CD-RW disc.
• Burn the file to the disc using disc-at-once mode (2x Speed) and ISO 9660 CD-ROM file system format. (The player will not recognize the update disc and the update cannot be performed if the file is not burned correctly to the disc.)
• Make sure that the disc session is closed / the disc is finalised.

5. Update your device

• Update the firmware using the CD-R or CD-RW disc containing the firmware file.
• Perform the update following the procedure given in the PDF DVJ-1000 update instructions.

Note: Do not turn off or disconnect power, or remove a disc while update is in progress.